6
FOR YOUR REFERENCE
6-3
■ Troubleshooting (continued)
PROBLEM POSSIBLE CAUSE SOLUTION
REFERENCE
“Paring list is full” is
displayed in the Pairing
screen.
Number of paired devices exceeds the
maximum number.
Delete a Bluetooth device from the
pairing list. p. 5-21
The call was suddenly
cut off /Noise is heard
Too far from the Bluetooth device.
(When using a Bluetooth headset)
Get closer to the Bluetooth device.
L The communication range of
Bluetooth is approximately 10
meters (33 feet).
–
Electromagnetic interference from other
electronic devices.
Use the transceiver away from the
other devices, or stop using those
devices.
–
No audio output from
IP501H after
the
Bluetooth connection
with BC-218 is
disconnected.
IP501H is in the Bluetooth signal detecting
sequence. (Approximately 20 seconds)
Push the Bluetooth button on the BC-218
to disconnect the Bluetooth device,
then turn OFF the BC-218 power. –
No sound comes from
the earphone that is
connected to the VS-3.
The volume level is set too low. Increase the VS-3's volume level. p. 5-11
Increase the IP501H's volume level.
(
When "Bluetooth Synchronous Volume"
is set to valid)
pp. 1-3, 4-6
Loose earphone plug connection. Firmly insert the plug. p. 1-4
To Next Page
Loading...
