ICON ProAudio Platform X+ - Page 46

46

 Also, according to your using DAW, select the control protocol (MCP or HUI)
2
in
order to create the communication bridge between your Platform X+ to the DAW.
Please refer to below table for the suggested control protocol for different DAW.
 “Suggested protocol for different DAW”
 “Control elements chart”
Message
type
Channel Message
Slide Pitch 1-16 0-127
Note 1-16 C(-1) to G(9)
CC 1-16 Bank MSB to Poly Mode On
Program 1-16 0-127
Slide CC - Volume 1 to X-fader touch master
Touch sensive CC - Volume 1 to X-fader touch master
Rotate CC 1-16 Bank MSB to Poly Mode On
Note 1-16 C(-1) to G(9)
CC 1-16 Bank MSB to Poly Mode On
Program 1-16 0-127
Rotate CC - Volume 1 to X-fader touch master
Enter CC - Volume 1 to X-fader touch master
Note 1-16 C(-1) to G(9)
CC 1-16 Bank MSB to Poly Mode On
Program 1-16 0-127
All buons except
"Lock" buon
All buons except
"Read", "Write",
"Lock", "Hori-Zoom"
& "Vert-Zoom"
MCP
Buons
HUI
Enter
MCP
HUI
Knobs
CC - Volume 1 to X-fader touch master
Faders
HUI
MCP
Touch sensive
Avalaible MIDI message seng values
ElementControlControl protocol