41
Assigning DAW mode (Mackie control/HUI
with iMap
TM
Tip: You may also use the hardware to select DAW mode
instead of through iMap. Please refer to P.23 for instructions.
To begin DAW mode setup, connect your Platform X+ with iMap. Follow the
steps below:
1. Connect Platform X+ to your Mac/PC.
2. Launch iMap and click “Connect Device”.
Note: If your Platform X+ is not connected to your Mac/PC, the message “There
are no MIDI input devices” will appear. Please connect Platform X+ to your
Mac/PC with the provided USB cable.
iMap
TM
Platform X+ software panel
Diagram 8
To Next Page
Loading...
