8
<< / >> buttons - These arrow buttons are used to scroll through the DAW list.
The name of the DAW will display on the LCD if Platform D / Platform D2 is
installed, otherwise please refer to p.10 for the LED sequency vs DAW mode.
DAW button - Press to enter the DAW selection.
To change your Platform X+ DAW mode, turn off and on the power switch to
enter the DAW selection mode. Select your desired DAW from the list with the
“<<” / “>>” buttons.
Note: You have to select the “Unit Number” for Paltform X+ before you select
the DAW. Thumb of rule, the unit next to Platform M+ is always start with unit
number 1, the next unit is number 2 and the farest device is number 3.
Tips: DAW button could not be activated if a DAW software is running.
(Note: We will update Platform X+ rmware from time to time to support
additional DAW apart from the current existing list. Please check our ofcial
website www.iconproaudio.com to download and upgrade your Platform X+
rmware or simply sign up our newslatter on the bottom of our website’s front
page, that will also keep you up-to-date for our rmware release ).
(Tips: Platform X+ will memorize your last selected DAW mode and re-enter the
same mode few seconds after it’s been switched on. (i.e. DAW mode selection
is not needed if last mode is being used.)
4
To Next Page
Loading...
