BIA-DPC1 rev 4 Page 40
Hold pressing the STORE key and press the A STOP key. The control panel makes a “beep” sound and displays
the accumulative run time.
The pump has run for 23 hours.
Press the A STOP key to quit the accumulative running time display.
Repeat for pump B by using B STOP key.
5.8 Pump disable.
To disable a pump independently press A STOP or B STOP and MODE at the same time.
6.0 Communication link.
The control panel has communication interface, that along with the optional Slave Controller, users can realise
a long distance monitoring function.
This function applies to where the control panel is installed in the basement or pumping room, but users
require to monitor and control the pump on the ground or in a control room.
To Next Page
Loading...