Tiny Modbus/TCP to RTU/ASCII Gateway
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved. - 67 -
This parameter is used to configure the Modbus TCP port.
Note: The default COM1/COM2/COM3 = TCP Ports 502/503/504.
Swap the High/Low byte reading order of Length in the Modbus TCP
header.
Connection Idle (seconds)
If Modbus TCP communication is idle for a specified period of time,
the system will automatically terminate the connection.
Valid range: 1to 65535 (seconds); Disable= 0;
To Next Page
Loading...
