ICP DAS USA tGw-735 - Appendix A: Troubleshooting; A1. How do I restore the web password for the module to the factory default password?

To Next Page

To Previous Page

Tiny Modbus/TCP to RTU/ASCII Gateway

Appendix A: Troubleshooting

A1. How do I restore the web password for the module to the factory default

password?

The instructions below outline the procedure for resetting the web password to the factory default

value. Note: Be aware that ALL settings will be restored to the factory default values after the module is

reset.

Step 1 Locate the Init/Run switch that can be found on

the right-hand side of the tGW-700/GW-2200 module

and set it to the "Init" position. Reboot the module to

load factory default settings including default web

password.

Step 2 Execute the eSearch Utility to search for any tGW-700/GW-2200 modules connected to the

network. Verify that the tGW-700/GW-2200 has been reset to the original factory default settings.

For example, the module should be shown as having the default IP address, which is 192.168.255.1.

Related product manuals