Tiny Modbus/TCP to RTU/ASCII Gateway
Copyright © 2020 ICP DAS CO., Ltd. All Rights Reserved. - 88 -
5. In the Pair-connection Settings area of the Port1 Settings page, check that the configuration
details are the same as those shown below.
Modbus Protocol, IP address and TCP port of the slave device (e.g., tPET-P6)
6. Amend any details as required and then click the “Submit” button to complete the configuration.
Step 4: Testing the Pair-connection (TCP Client Mode) Functions
For more detailed information regarding the testing procedure, refer to Step 5 (Figures 6-8 to 6-10) in
the Section 6.3 “Pair-connection Applications”.
To Next Page
Loading...
