29
Copyright © 2005 ICS, Blount Inc.
633GC SHOP MANUAL
10 This section covers the
disassembly and assembly of
the cylinder cover. Removal of
the air intake components and
front handle is required. Refer to
sections 5 and 18 if necessary.
10.1 Remove the cylinder cover screws.
10.2 Remove spark plug lead from
cylinder cover.
10.3 Partially remove intake manifold from
cylinder cover while lifting cylinder
cover away from saw.
10.4 Inspect cylinder cover for damage.
A Replace if necessary.
10.5 Make sure carburetor screw boot and
cylinder cover plug are in place.
10. CYLINDER COVER
To Next Page
