ICS 633GC - Muffler; Muffler Removal and Installation

31
Copyright © 2005 ICS, Blount Inc.
633GC SHOP MANUAL
11 This section covers the
disassembly, inspection,
and assembly of the muffler.
Removal of the WallWalker
®
and cylinder cover is required.
Refer to sections 9 and 10 if
necessary.
11.1 Bend the corner of the muffler screw
locking plate away from the muffler
screw.
11.2 Remove muffler screws, muffler
support bracket nut, and muffler
assembly.
11.3 Clean and inspect parts of muffler
assembly.
A Replace any damaged components.
11.4 Install muffler.
A Assemble muffler screws, muffler
support bracket, muffler screw
locking plate.
B Thread muffler screws into cylinder;
torque to 104 in-lbs. (11.75 Nm).
C Bend muffler screw locking plate over
flat edge of muffler screw.
D Install muffler support bracket nut
(use blue Loctite
®
); torque to 26 in-
lbs. (2.9 Nm).
11. MUFFLER