iDataLink Maestro User Manual

The brand names and logos found in this guide are property of their respective owners. Automotive Data Solutions Inc. © 2011
Rev. Date: April 10, 2012
Doc. No.: ##----=##
VERSION FRANÇAISE DISPONIBLE EN LIGNE AU WWW.IDATALINK/(TBD)
PLEASE VISIT WWW.IDATALINK.COM/SUPPORT FOR COMPLETE PRODUCT DETAILS
MAESTRO INSTALL GUIDE
Procedures for vehicles not currently covered
NOTICE: The manufacturer will accept no responsibility for any electrical damage resulting from
improper installation of this product, be that either damage to the vehicle itself or to the installed
device. This device must be installed by a certified technician. This guide has been written for
properly trained technicians; a certain level of skill & knowledge is therefore assumed. Please review
the Installation Guide carefully before beginning any work.

iDataLink Maestro Specifications

General

Brand	iDataLink
Model	Maestro
Category	Automobile Electronics
Language	English

Summary

Maestro Install Guide

Important Notice

Manufacturer disclaims responsibility for electrical damage due to improper installation.

Required Tools

Radio Wiring Identification

Identify Power and Ground

Procedure to identify 12V(+) and Ground using a Digital Multimeter.

Identify Radio Harness Wires

Steps to identify specific wires of the vehicle's radio harness.

Test Steering Wheel Controls

Testing steering wheel buttons by measuring resistance changes.

External Module Wiring Identification

Locate and Test External Module

Locating the external module and testing its wiring with a DMM.

Link Steering Wheel Buttons

Linking steering wheel buttons to the signal wire of the external module.

Measure Resistance Values

Measuring resistance values between ground/signal wires and buttons.