IDEAL Networks NaviTEK NT - Setup Menu

NaviTEK NT 153800 Iss 1
User Guide Page 11
NOTES
If the NaviTEK NT is connected to an active network when it is switched ON, it will
automatically detect the network and display its IP address in the HOME screen.
If the NaviTEK NT is not connected to an active network when it is switched ON, it will
automatically enter Cable mode and run a Wiremap test.
If the NaviTEK NT is connected to an active network after it is switched ON, press the soft
key DETECT (F1) to detect the network.
Setup
All user-defined settings and preferences of the NaviTEK NT are set from the SETUP menu.
Fig 8
Setup menu descriptions
From the Cable or Ethernet home screen,
press the soft key SETUP (F3) to display the
Setup menu .
Selecting any of the icons will produce the
options that follow:
Fig 9
ABOUT
UPDATE
PREF
LANG
FACTORY
IPv4
IPv6
RJ45
SETUP
SYSTEM