IDEAL Networks NaviTEK NT - Ethernet Mode Test Descriptions

NaviTEK NT 153800 Iss 1
User Guide Page 19
Tests menu description – Ethernet mode
When the TESTS icon from the Ethernet mode home screen is selected, Fig 29, the available
IP tests will be displayed on the Tests screen as shown in Fig 30.
Fig 29
Fig 30
Blink
A Hub Blink test forces the connected port of a network device to blink. NaviTEK NT also
changes the speed and therefore LED color (on supporting devices) making it easier to
identify the correct port. Select the BLINK icon from the Tests screen, the test is started and
stopped with the soft key F1 which displays as RUN or STOP accordingly.
Ping4 and Ping6
Ping will test the availability and measure the response times of devices and URLs.
The results of a successful test, both in progress and passed are shown. The range of possible
results are listed next to the figure.
• Info: READY,
IN PROGRESS, PASSED,
NO RESPONSE,
UNKNOWN HOST.
•
Tx: Count of transmitted ping
frames: 1 to 999999.
•
Rx: Count of successfully
received Ping responses: 1 to
999999.
•
Delay: Round trip delay in ms
between transmitting Ping
and
receiving response.
Displayed as Minimum,
Average and Maximum.
Fig 31