IDEAL Networks NaviTEK NT - TRoute4 Test; Ping6 Test; TRoute6 Test; Autotest Configuration

NaviTEK NT 153800 Iss 1
User Guide Page 14
Set the target URL/Numerical address.
Timeout (Abort timeout for any hop: 2 to 30 secs), Use a short timeout to
reduce test time, or a long timeout to reach remote internet locations.
Protocol (ICMP or UDP as required by your network).
Select Name Lookup if supported by your network. If not required, de-
select Name Lookup to reduce test time.
Set the target URL/Numerical address,
Count (Number of times to repeat the Ping - 1 to 999999),
Pause (Interval between successive Pings - 1 to 5 seconds),
Length (Number of bytes in the Ping frame payload - 8 to 1000 bytes).
Set the target URL/Numerical address,
Maximum number of hops (1 to 30),
Timeout (Abort timeout for any hop - 2 to 30 secs),
Select Name Lookup if supported by your network. If not required, de-
select Name Lookup to reduce test time.
Select the Cable mode and Ethernet mode tests that will run every time the
NaviTEK NT’s Autotest button is pressed. Select from: Wiremap, Ping4,
Ping6, TRoute4, TRoute6.
For all tests a symbol is displayed at the top right hand corner of the screen below the
information bar.
Indicates test has not been run and that the tester is ready.
Indicates test is in progress. This symbol is also displayed while the tester is detecting a
port.
Will be displayed if the test is aborted, or when a test has been run and a fault detected
or a network is unknown or unreachable.
Indicates a test has been run with no faults detected.