IDEAL 7228-95 User Manual

- 12 -
IDEAL 7228-95
67-04
3.5 Programming
The control system enables 20 programs with up to
16 steps to be programmed. One step represents
one measurement or max. 9 chain measurements.
P Program
S Step
M Memory
£ Program up
¢ Program down
C Clear
D Delete
I Insert
E Eject
Clear Program
Each program step corresponds to one dimension.
The indicated program step can be overwritten at
any time. These programs remain stored when the
machine is off. Should you change to another
dimension unit all programmed measures are
converted into the new unit (cm and inch).
Program entry:
- Press
P © the red „S“ light will be on.
- Enter desired program number
0 1...2 0. ©
The number will be shown in the display (10).
- Press the button
twice © previous program is
deleted.
- Enter the position.
- Confirm with
=.
-
£ choose the next step.
- Enter the next position
Confirm with
=
- P Exiting program-mode.
Eject function
This function can only be programmed to one
position.
- Press
E = .

IDEAL 7228-95 Specifications

General

Brand	IDEAL
Model	7228-95
Category	Paper Cutters
Language	English