OPERATION
When there is a demand for heat, the heating system is supplied
at the selected temperature of between 30
o
C and 82
o
C.
The boiler features a comprehensive diagnostic system which
gives detailed information on the boiler status when operating, and
SAFE HANDLING
This boiler may require 2 or more operatives to move it to its
installation site, remove it from its packaging base and during
movement into its installation location. Manoeuvring the boiler
may include the use of a sack truck and involve lifting, pushing
and pulling.
Caution should be exercised during these operations.
Operatives should be knowledgeable in handling techniques when
performing these tasks and the following precautions should be
be made to ensure the following unless unavoidable and/or the
weight is light.
if required.
OPTIONAL EXTRA KITS
FLUING:
Flue Extension Ducts. (1000mm long)
90
o
Elbow Kit (60/100 dia maximum no. per installation)
45
o
Elbow Kit (60/100 dia maximum no. per installation)
Concentric Flue Screw Retaining Kit
Roof Flue Kit (60/100)
Pitched Roof Tile
Flat Roof Tile
Vertical Flue Adaptor
Vertical Outlet Flue Kit with Elbow (60/100)
Flue Finishing Kit
High Level Flue Outlet Kit
Flue Deector Kit
OTHER OPTIONAL KITS:
Remote User Control Kit
Condensate Pump Kit
Concealment Panel Kit
RS Boiler Terminal Wall Plate Kit
Adjustable Flue Support Bracket
SAFETY
Current Gas Safety (Installation and Use) Regulations or
rules in force.
should be installed in accordance with the rules in force.
In GB, the installation must be carried out by a Gas Safe
Regulations, The Building Regulations (Scotland), Building
Regulations (northern Ireland).
made to the relevant British Standard Code of Practice.
Installer and installed in accordance with the current edition
rules for electrical installation.
BS. 5440:1 Flues (for gas appliances of rated input not
exceeding 70 kW).
BS. 5440:2 Ventilation (for gas appliances of rated input not
exceeding 70 kW).
BS. 5449 Forced circulation hot water systems.
BSEN. 12828:2003
water based heating systems.
BSEN 12831:2003
calculation of the design heat load.
BSEN 14336:2004
and commissioning of water based heating
systems.
BS. 5546 Installation of gas hot water supplies for domestic
purposes (2nd Family Gases).
BS. 6798
input not exceeding 60 kW.
BS. 6891 Low pressure installation pipes.
Health & Safety Document No. 635
The Electricity at Work Regulations, 1989.
The manufacturer’s notes must NOT be taken, in any way, as
overriding statutory obligations.
IMPORTANT.
and performance. It is, therefore, important that no external
directly connected to these appliances unless covered by
these Installation and Servicing Instructions or as otherwise
recommended by Ideal Boilers in writing. If in doubt please
enquire.
Any direct connection of a control device not approved by Ideal
Boilers
warranty. It could also infringe the Gas Safety Regulations and
the above regulations.
SAFE HANDLING OF SUBSTANCES
Care should be taken when handling the boiler insulation panels,
which can cause irritation to the skin. No asbestos, mercury or
CFCs are included in any part of the boiler or its manufacture.
To Next Page
Loading...
Need help?
General
