IDEAL SecuriTEST User Manual

32
to move the camera to the stored
position.
SPST: Short for SET PRESET - Memorizes
PRESET. Setup can range from 1 up to 99.
First, move the camera to the desired
position. Press the
key to activate
the menu, then using the
& keys,
select SPST and set the address to store
using the
& keys. Press the
key once more to save the
address. This function saves the current
camera position into the cameras internal
memory. This set position can be recalled
from SecuriTEST or any other PTZ
controller at a later time.
TOUR: Operates TOUR through SPST points. Can
be programmed from 1 to 99. TOUR is set
using the same process described for the
SPST function. To program the camera tour,
the camera must support programming via
the SecuriTEST interface. This is accessed
by using the MENU function on the
SecuriTEST PTZ screen. If the camera
already has tours programmed, use the
TOUR mode to recall and activate a tour
that was previously saved in the camera.
SPD: Sets the speed of the camera. Programmed
using the same described for SPST. Range
is from 1 to 16. Always defaults to 15 when
cycling power or changing modes. High
speeds are preferred to test the cameras
operation while low speeds are used for
precise control when storing set points
(SPST).

IDEAL SecuriTEST Specifications

General

Brand	IDEAL
Model	SecuriTEST
Category	Test Equipment
Language	English