6
- Battery Precautions -
The following batteries can be used with SecuriTEST:
> AA size alkaline batteries
> AA size rechargeable nickel metal hydrogen
(Ni-MH) batteries
When charging batteries in SecuriTEST:
Place both the MAIN POWER and the CHARGE
SWITCH to the “ON” position. The charge LED will light
when the MAIN POWER SWITCH is in either position,
but the batteries will charge only
when the switch is set
to “ON”.
The CHARGE SWITCH is located on the upper part of
battery compartment. (Refer to the figure below)
The performance of batteries can be very different,
depending on manufacturers. Please use any reputable
brand for best performance. Do not mix batteries of
different manufacturers when charging batteries. Make
sure not to reverse the polarization of the batteries. Do
not short-circuit or disassemble batteries. Make sure to
check the polarization, voltage and current ratings before
charging batteries. Immediately disconnect the charger
should an abnormal situation arise.