IDEC HG4F

41
5
Chapter 5 Verify Operation
Verify Operation
www.IDEC.com/software
2. Double-click the Value cell for
device address D 10 .
Up and down buttons are displayed.
3. Click [ ] to set the value and
press [Enter].
In this example, the value is 5 .
The value will be displayed in the
[Numerical Target] numerical input field
on the Operator Interface.
If the value does not display in the numerical input field, check the
devices for the [Numerical Target] numerical input field.
(Refer to " Numerical Target input field" on page 30.)
End Debugging Mode
Once debugging is complete, exit debug mode.
Click the (Stop Debug-
ging) icon.
