IFM Electronic DTE101 - Operating and Display Elements; 7�1 Reset to Factory Settings; 7�2 LED Indicators; 7�2�1 Led Aux

13
UK
7 Operating and display elements
7.1 Reset to factory settings
The Ethernet parameters can be reset to the factory settings� Take the following
steps:
► Remove all cable connections from the device�
► Insert an electrically conductive bridge between pin 1 and pin 3 on the process
connection IO-3�
► Connect device with the voltage supply and wait until the yellow LED indication
on AUX and IO-3 flashes at approx� 8 Hz�
► Disconnect the device from the voltage supply and connect it again�
> The settings are reset�
7.2 LED indicators
The device indicates the current status of the interface via the status LEDs�
7.2.1 LED AUX
LED green LED yellow Status Note
Off Off No voltage supply U
AUX
< 5 V
On
Flashes at
2 Hz
Voltage supply too low 5 V ≤ U
AUX
≤ 18 V
On Off Voltage supply OK 18 V ≤ U
AUX
≤ 36 V