12
7.2 Explanation of the menu
SPx Set point (upper limit value) with hysteresis function
rPx Reset point (lower limit value) with hysteresis function
FHx Set point (upper limit value) with window function
FLx Set point (lower limit value) with window function
Mmod Measurement method (2-wire, 3-wire or 4-wire temperature sensors):
3w = 3-wire measurement
4w = 2-wire and 4-wire measurement
EF Extended functions� Opening of the lower menu level�
rES Restoring the factory settings
oux Output function OUTx:
Hno = Hysteresis function normally open
Hnc = Hysteresis function normally closed
Fno = Window function normally open
Fnc = Window function normally closed
dSx Switching delay on OUTx in seconds
drx Switch-off delay on OUTx in seconds
FOUx Behavior of output OUTx in case of an internal fault�
On = Output switches on in case of a fault�
OFF = Output switches off in case of a fault�
uni Standard unit of measurement for temperature (°C or °F)
P-n Output logic: pnp / npn
Lo
Minimum value of the temperature measured in the process since the last
reset or deletion of memory�
Hi
Maximum value of the temperature measured in the process since the last
reset or deletion of memory�
coF Zero-point calibration� The internal measured value 0 is shifted by this value�
cFH Upper limit value for colour change temperature�
cFL Lower limit value for colour change temperature�
To Next Page
Loading...
