IFM Electronic efector600 TR7439 - 8�1 Parameter Setting in General; 8�1�1 Change between the Menus; 8�1�2 Change to the Process Value Display (RUN Mode)

14
8.1 Parameter setting in general
1� Change from the RUN mode to the main menu [●]
2� Select the requested parameter [▲] or [▼]
3� Change to the setting mode [●]
4� Modification of the parameter value [▲] or [▼] > 1 s
5� Acknowledge the set parameter value [●]
6� Return to the RUN mode → 8.1.2
Press [▲] + [▼] simultaneously to leave the setting mode without saving
the changed parameter�
If [C�Loc] is displayed when attempting to change a parameter value, a
change is made via a parameter setting software at the same time (tempo-
rary locking)�
If [S�Loc] is displayed, the sensor is permanently locked via software� This
locking can only be removed with a parameter setting software�
8.1.1 Change between the menus
1� Change from the RUN mode to the main menu [●]
2� Select parameter EF [▼]
3� Change to the submenu EF [●]
4� Select parameter CFG, MEM, DIS [▼]
5� Change to the submenu CFG, MEM, DIS [●]
6� Return to the next upper menu [▲] + [▼] simultaneously
8.1.2 Change to the process value display (RUN mode)
There are 3 possibilities:
I� Wait for 30 seconds (→ 8.1.4)�
II� Press [▲] until the RUN mode is reached.
III� Press [▲] + [▼] simultaneously until the RUN mode is reached.