8.1.3 Locking / Unlocking
The unit can be locked electronically to prevent unintentional settings�
On delivery: not locked�
Locking ► Make sure that the unit is in the normal operating mode�
► Press [▲] and [▼] simultaneously for 10 s until [Loc] is displayed.
During operation: [Loc] is briefly displayed if you try to change
parameter values�
Unlocking ► Make sure that the unit is in the normal operating mode�
► Press [▲] and [▼] simultaneously for 10 s until [uLoc] is displayed.
8.1.4 Timeout
If no button is pressed for 30 s during parameter setting, the unit returns to the
operating mode with unchanged values�
8.1.5 Configure colour change display
► Select [coLr] and define the colour of the process value display:
rEd, GrEn, r1ou, r2ou, G1ou, G2ou, r-12, G-12, r-cF, G-cF (→ 3.2)�
[coLr]
8.1.6 Setting of the limit values for colour change
► Select [cFH] and set the upper limit value�
► Select [cFL] and set the lower limit value�
[cFH] and [cFL] are only displayed if [coLr] = r-cF or G-cF�
[cFH] und [cFL] are irrespective of the default set points� The setting
range corresponds to the measuring range and its minimum limit is
[cFL] and its maximum limit is [cFH]�
[cFH]
[cFL]
8.1.7 Resetting all parameters to factory setting
► Select [rES]�
► Press [●].
► Press [▲] or [▼] and keep pressed until [----] is displayed.
► Briefly press [●].
It is recommended to take down your own settings in the table before
carrying out the function → 11 Factory setting�
[rES]
To Next Page
Loading...
