SP1
FL2
FH2
MAW MEW
Outputs with hysteresis and window
function:
Colour change if the measured value is
outside the switching limits�
3.3 IO-Link
3.3.1 General information
This unit has an IO-Link communication interface which requires an IO-Link-capa-
ble module (IO-Link master) for operation�
The IO-Link interface enables direct access to the process and diagnostic data
and provides the possibility to set the parameters of the unit during operation�
In addition communication is possible via a point-to-point connection with a USB
adapter cable�
You will find more detailed information about IO-Link at www�ifm�com/gb/io-link�
3.3.2 Device-specific information
You will find the IODDs necessary for the configuration of the IO-Link unit and
detailed information about process data structure, diagnostic information and
parameter addresses at www�ifm�com/gb/io-link�
3.3.3 Parameter setting tools
You will find all necessary information about the required IO-Link hardware and
software at www�ifm�com/gb/io-link�
4 Installation
► Connect the unit to a temperature sensor and fix it with the help of mounting
accessories�
Mounting set for direct connection of temperature sensors TT: E30017�
Further information of mounting accessories at www�ifm�com�
To Next Page
Loading...
