5
UK
• For the installation the standards EN 60204, EN 999 and ISO 13855 have to be
adhered to (the response times of all safety components have to be observed)�
• In case of malfunction of the unit please contact the manufacturer� Tampering
with the unit is not allowed�
• Disconnect the unit externally before handling it� Also disconnect any indepen-
dently supplied relay load circuits�
• After setup the system has to be subjected to a complete function check�
• Use the unit only in specified environmental conditions (→ 10 Technical data)�
In case of special operating conditions please contact the manufacturer�
WARNING
In case of improper handling of the product, the safety and physical inte-
grity of operators and machinery cannot be guaranteed.
Death or serious irreversible injuries may result�
► Observe all notes on installation and handling in these instructions�
► The safety relay must only be used under the specified operating conditions
and in accordance with use as prescribed below�
3 Items supplied
• 1 G2001S safety relay
• 1 copy of the operating instructions safety relay, reference 704576�
If one of the above-mentioned components is missing or damaged, please contact
one of the ifm branch offices�
To Next Page
Loading...