OPERATION MANUAL
IFF-701Ti
INDEX
Page
1
Jul 1/00
INDEX
90 Hz and 150 Hz Tones
Phase Relationships Table 1-2-3, p 13
1-3-1, p 3
Localizer (LOC) 1-2-3, p 12
Glide Slope (G/S) 1-2-3, p 12
Abbreviations App C, p 1
ac Power Requirements 1-2-1, p 2
Battery
Charging 1-2-1, p 1
Operation 1-2-1, p 1
Parameters 1-2-3, p 2
Recharging 1-2-1, p 2
Bench Operation 1-2-1, p 3
1-2-3, p 2
Capabilities, General Description and 1-1-1, p 1
CAUTION and WARNING Labels 1-2-1, p 2
Charging, Battery 1-2-1, p 1
Communication Operation (Receiver) 1-2-3, p 7
Communication Operation (Transmitter) 1-2-3, p 8
Complying with Instructions 1-2-1, p 1
Controls, Connectors and Indicators 1-2-2, p 2
Front Panel 1-2-2, p 4
Rear Panel 1-2-2, p 10
Correspondence Chart
90 Hz and 150 Hz Tones (LOC) 1-2-3, p 12
90 Hz and 150 Hz Tones (G/S) 1-2-3, p 12
Decibels, Volts and Watts 1-2-3, p 9
Counter Operation 1-2-3, p 2
Description 1-1-1, p 1
External Cleaning 1-2-1, p 3
FCC Requirements 1-2-1, p 2
Functional Capabilities 1-1-1, p 1
Fuse Ratings, Specified 1-2-1, p 2
General Description and Capabilities 1-1-1, p 1
General Operating Procedures 1-2-3, p 1
Glide Slope Operation 1-2-3, p 6
Grounding Power Cord 1-2-1, p 1
Indicators, Controls, Connectors and 1-2-2, p 2
Front Panel 1-2-2, p 4
Rear Panel 1-2-2, p 10
Input Power Versus Time Limits 1-3-1, p 7
Installation 1-2-1, p 1
I/O Connectors
AC POWER App A, p 1
RF OUT App A, p 1
COM XMTR IN App A, p 1
MOD IN/EXT FREQ CTR IN App A, p 1
NAV TONES DEMOD OUT App A, p 1
SIGNAL GENERATOR DEMOD OUT App A, p 1
COM XMTR DEMOD OUT App A, p 1
Localizer Operation 1-2-3, p 5
Low-Pass Filter Diagram 1-3-1, p 5
Marker Operation 1-2-3, p 3
Metric/British Imperial Conversion
Table with Nautical Distance
Conversions App B, p 1
Operate LOC and G/S Simultaneously 1-2-3, p 2
Operation 1-2-1, p 1
Battery 1-2-1, p 1
Bench 1-2-1, p 3
1-2-3, p 2
CAUTIONS 1-2-3, p 1
Communication (Receiver) 1-2-3, p 7
Communication (Transmitter) 1-2-3, p 8
Counter 1-2-3, p 2
Glide Slope 1-2-3, p 6
Localizer 1-2-3, p 5
Marker 1-2-3, p 3
Ramp 1-2-3, p 1
Safety 1-2-1, p 1
VOR 1-2-3, p 4
Parameters, Battery 1-2-3, p 2
Power Cord, Grounding 1-2-1, p 1
Power Requirements, ac 1-2-1, p 2
Ramp Operation 1-2-3, p 1
Recharging, Battery 1-2-1, p 2
Repacking Procedure 1-4-1, p 1
Safety Precautions 1-2-1, p 1
Shipping Test Sets 1-4-1, p 1
Signals Simulated 1-2-3, p 1
Specifications 1-3-1, p 1
AC Power Requirements 1-3-1, p 9
Battery 1-3-1, p 8
Bearing Monitor 1-3-1, p 8
COM Mode 1-3-1, p 6
Environmental 1-3-1, p 9
External Frequency Counter 1-3-1, p 7
G/S Mode 1-3-1, p 5
LOC Mode 1-3-1, p 4
Marker Mode 1-3-1, p 2
Power Meter 1-3-1, p 8
RF Output 1-3-1, p 1
VOR Mode 1-3-1, p 3
Specified Fuse Ratings 1-2-1, p 2
Storing Test Sets 1-5-1, p 1
VOR Operation 1-2-3, p 4
WARNING Labels, CAUTION and 1-2-1, p 2
To Next Page
Loading...