iGenix IG9902 - Mains Plug Fuse Replacement; Fuse Replacement (Class I)

12
The unit is
noisy?
Problem Cause Solution
Unit stands uneven! Ensure that the unit is standing on a
atevensurface.
The compressor
doesn’t work?
The overheating
protection has activated!
Wait until the unit has cooled
down before trying again
Remote control
doesn’t work?
The batteries are
drained!
Replace with new batteries.
Remote control signal
not being picked up by
the control panel!
Ensure you are not too far
away from the unit.
Make sure the remote control is
correctly aimed at the control panel.
The unit doesn’t
seem to cool the
room down?
Is there direct sunshine
in the room?
Close any curtains or blinds.
Too many windows or
door open!
Close a door or window to
reduce the loss of cold air.
Is there something in the
room producing heat?
Turn any heater etc. off.
Theltersaredirty! Cleanorreplacelters.
Air inlets or outlets are
blocked!
Conrmthatthereisnothing
obstructing the inlets and outlets.
MAINS PLUG FUSE REPLACEMENT
Fuse Cover
Fuse Replacement (Class I)
This appliance must be eathed. Remove the fuse cover with a small
atheadscrewdriver.Takeoutthefuseandreplacewithanewfuse
of the same Amp. Replace the fuse cover and push back into place.