3 – 13
MAINTENANCE
Walk-Around Inspection
Inspect the operator’s compartment for
cleanliness. Keep it clean.
Inspect the loose bolts, Tighten any loose bolts.
Repair if necessary..
Inspect any cracks in boom and arm pivot area
and cylinder mounting brackets.
Repair if damaged.
Inspect attachment cylinders, linkage and bucket
for damage or excessive wear. Repair if damaged.
Inspect and remove any trash build up in the
engine compartment.
Inspect the cooling system for leaks, faulty hose
and trash built up. Correct any leaks and remove
any trash from the radiator.
Inspect the hydraulic system for leaks. Inspect the
tank, cylinder rod seals. tubes, plugs, joints and
fittings. Correct any leaks.
Inspect and repair travel drive leaks. Check oil
level if leakage is noticed.
Daily Lubrication
Perform the daily lubrication as required by the
Lubrication Chart.
DAILY
To Next Page
Loading...
