900861-00NC
11
IHP.us.com
SEE-THROUGH FIREPLACE
DIMENSIONS AND
CLEARANCES SECTION
NOTE: Preparation for the LED lighting and the inlet gas line must be
planned before the fireplace is installed. See Page 5, Figure 1 for inlet
gasline and Page 15 for LED lighting.
SEE-THROUGH FIREPLACE DIMENSIONS AND CLEARANCES
This fireplace comes with various boxes prepackaged inside the fireplace. Do not discard
any boxes unless notes to do so. Read the list below for the contents.
Component Parts Box Contents:
(1) RGB Control Assembly (includes switches and LED dimmer)
(1) 12VCD Adaptor (used for LED lighting)
(1) 7.5VCD Adaptor (used for valve system)
(2) Pilot Covers (used inside burner pan area)
(2) 6x12 Black Vents (used to ventilate enclosure)
(12) Black Screws, Nuts & Washers for 6x12 vents
(1) Installation manual for vent kit
(1) 24-inch LED wire harness
(1) 10-foot valve system (module) wire harness
(1) LED 10-foot controller wire harness
Windshield Parts Box Contents:
(2) Glass Windshields (inside firebox)
(4) LED Retainer Clips (2 for singled-sided; 4 for see-through fireplace)
(8) Glass Windshield Clips (4 for singled-sided; 8 for see-through fireplace)
(2) Stainless Steel Hoods (1 for singled-sided; 2 for see-through fireplace)
LED Assemblies Box Contents:
(1) LED Tray Assembly Left
(1) LED Tray Assembly Right
(4) LED Glass Retainer Clips & Pan Head Screws
(8) Windshield Clips & Pan Head Screws
Glass Media Box Contents:
(3-5) bags of diamond crystal media depending on model size (See Table 7 and Figure
33 on Page 24 for reference)
To Next Page
