What to do if fans do not run and LED is off on the Ihse Draco tera 480 Switch?
If the fans are not running and the LED is off, the cause may be the power supply. Check the power supply and power connection.
What to do if the Ihse Draco tera 480 matrix cannot be started anymore?
If the matrix cannot be started, the cause might be a blown fuse at the standard appliance outlet. Check the fuse.
Why is the video display incorrect on my Ihse Switch?
An incorrect video display can be caused by a disturbed cable connection. Check the connection, length, and quality of the interconnect cable to the units.
What to do if fans only run under full load on Ihse Switch?
If the fans only run under full load, it indicates that the communication to the fan tray is not working. Here are a few things you can try: 1. Remove and reinstall the fan tray. 2. Swap both fan trays to the other slot. 3. Restart the matrix.
What to do if opening the OSD is not possible on the Ihse Switch?
If you cannot open the OSD, the cause may be that no OSD jumper is set. Set jumper 11 on the CON unit.
What to do if Ihse Gateway IP connection fails?
If the Ihse Gateway IP connection fails, there are several potential causes and solutions to consider: * If the destination type is set to EXT Unit, set the designation type to Grid. * If the destination data is incorrect, check the designation IP address of both IP Gateway boards. * Check the designation port of both IP Gateway boards. * Check the designation MAC address of both IP Gateway boards. * If the IP Gateway assignment is set in only one of the two matrices, ensure that you set the IP Gateway assignment in both matrices.
Details diagnostic and status information including LEDs and port status.
Details network configuration settings for the Draco tera.
Instructions for updating the matrix and extender firmware.
Instructions for updating the matrix firmware.
Covers operations using keyboard shortcuts like Direct Switching and Scan Mode.
Fastest method to switch consoles between different CPUs via favorites.
Explains switching operations between consoles and CPUs.
Allows switching any console to any available CPU.
General| Category | Switch |
|---|---|
| Model | Draco tera 480 Series |
| Ports | HDMI, DisplayPort |
| Resolution | Up to 4K |
| USB Support | USB 2.0 |
| Control | Web Interface, API |
| Power Supply | 100-240V AC |
To Next Page
