What to do if the Ihse Switch matrix cannot be started?
If your Ihse Switch matrix fails to start, verify that the power supply units are correctly locked and plugged in. Also, ensure the power supply cables are properly connected and the power supply units are switched on.
Why is there an incorrect video display on my Ihse Switch?
If you experience an incorrect video display with your Ihse Switch, check the connection, length, and quality of the interconnect cable to the units. A disturbed cable connection can cause this issue.
How to check the fuse on the Ihse Draco tera enterprise 480 if the matrix cannot be started anymore?
If the Ihse Switch matrix can no longer be started, check the fuse at the standard appliance outlet. A blown fuse could be the cause.
What to do if Ihse Draco tera enterprise 480 fans do not run, and the LED OK is off?
If the fans on your Ihse Switch do not run, and the LED OK is off, check the power supply and power connection. This indicates a potential power supply issue.
Why are network settings not assumed after editing on my Ihse Draco tera enterprise 480 Switch?
If network settings are not applied after editing your Ihse Switch, restart the matrix. The restart may not have been completed.
What to do if Ihse Draco tera enterprise 480 Switch fans only run under full load?
If the fans on your Ihse Switch only run under full load: 1. Remove and reinstall the fan tray, because communication to fan tray might not be working. 2. Swap both fan trays to the other slot. 3. Restart the matrix.
How to fix the issue of not being able to open the OSD on Ihse Switch?
If you cannot open the OSD on your Ihse Switch, set jumper 11 on the CON Unit. This issue occurs when no OSD jumper is set.
General| Model | Draco tera enterprise 480 Series |
|---|---|
| Category | Switch |
| Ports | 480 |
| Type | Matrix Switch |
| Video Formats | HDMI, DisplayPort, DVI, SDI |
| Audio Formats | Embedded audio, analog audio |
| Control | Web interface, serial interface, API |
To Next Page
