Ihse Draco tera enterprise 480 Series - Setting Autostart of the Device Finder; Fig. 100 Management Software Menu Extras - Options - Miscellaneous

Configuration via Management Software Draco tera enterprise
150
7.3.4 Setting Autostart of the Device Finder
Additional options for the matrix can be enabled in this menu.
Fig. 100 Management software menu Extras - Options - Miscellaneous
The following options can be enabled:
Option Description
Device Finder on
startup
Start the Device Finder automatically when starting the management software.
Name adoption Entered name for a CON/CPU Device is also applied to the EXT Unit and vice versa.
Show Super Grid
View
Show the Super Grid option in the task area.
Show power
backplane and fan
firmware
Show the firmware of the fans and the power backplane in the menu Status &
Updates > Status- Matrix Firmware.
Enable single I/O
board update on
compact switch
Option available only for Draco tera compact and Draco tera flex.
Enable splitted
firmware update
(matrix and extender)
for master and sub
part of the 576 matrix
Option available only for Draco tera enterprise 576.
To start the Device Finder automatically when starting the management software, proceed as follows:
1. Select Extras > Options in the menu bar and open the Miscellaneous tab.
2. Tick the Device Finder on startup checkbox.
3. Click Ok to confirm the changes.
4. Close the management software and restart it.
After restarting the management software, the Device Finder appears.