Ihse Draco tera enterprise 480 Series - Setting the SNMP Function; Fig. 112 Management Software Menu System Settings - Network - SNMP

Configuration via Management Software Draco tera enterprise
172
7.4.10 Setting the SNMP Function
The SNMP function allows all function-critical and safety-critical elements of the matrix to be monitored and
queried. This function complies with the RFC 1157 conformal standard. Two SNMP servers can be used at
the same time.
Enabling the SNMP function, the unencrypted SNMP monitoring (SNMPv2) is activated. An SNMPv3 User
for encrypted SNMP monitoring (SNMPv3) can be set in the user settings (see chapter 7.5.1, page 182)
and the login data for an SNMPv3 User at the SNMP server can be set in the default settings (see section
on page 176).
NOTICE
When using SNMP monitoring, for reasons of access security, the use of a dedicated network according
to the IT-Grundschutz-Kompendium (IT Baseline Protection) is recommended. The read only community
for the MIB file is kvm.
NOTICE
For an activation of the SNMP agent function or the SNMP server function, a restart of the matrix or the
controller board is necessary. Restarting the matrix or the controller board may take several minutes, and
the matrix is not available during the restart.
The settings for the SNMP monitoring are set in this menu:
Fig. 112 Management software menu System Settings - Network - SNMP