Ihse Draco tera enterprise 480 Series - Saving a Predefined Configuration; Fig. 95 OSD Menu Configuration - Save as

Draco tera enterprise Configuration via OSD
143
6.10.2 Saving a Predefined Configuration
In this menu, the current configuration can be saved in up to eight storage locations in the permanent
memory of the matrix memory (File #1 to File #8).
In addition to the eight memory locations, there is also a standard storage location (Default). A configuration
stored here can be loaded automatically every time the matrix is started instead of the last active
configuration (see chapter 6.3.1, page 72).
The current configuration is saved to the selected memory location and is immediately displayed in this
menu. The configuration previously saved at this memory location is overwritten. However, saving
predefined configurations does not replace saving the active configuration (see chapter 6.10.1, page 142).
Fig. 95 OSD Menu Configuration - Save as…
Saving position Name and detailed information
Active Name and detailed information of the current configuration are shown. This
configuration can be saved (function Save, see chapter 6.10.1, page 142).
Default
Name and detailed information of the respective saved configuration are shown.
This storage location can be overwritten.
File #1 to File #8 Name and detailed information of the respective saved configuration are shown.
These storage locations can be overwritten.
To save the created configuration to a specific memory location, proceed as follows:
1. Select Configuration > Save As… in the main menu.
2. Select the required storage location (File #1 to File #8) or Default.
The current configuration is saved to this storage location and is shown immediately in the menu. The
previously saved configuration saved to this storage location is deleted.