Ihse Draco tera enterprise 480 Series - USB 2.0 Switching

Operation via OSD Draco tera enterprise
304
9.1.3 USB 2.0 Switching
Switching of USB 2.0 extender modules basically works like switching of KVM extender modules. The
following scenarios to switch USB 2.0 extender modules are possible.
1. An EXT Unit with USB 2.0 will be created and assigned to an already existing device with existing KVM
EXT Units (see chapter 6.6.1, page 108 or chapter 6.7.3, page 119).
2. A separate device for the EXT Unit with USB 2.0 will be created without assigning a KVM EXT Unit to
that device. This possibility offers a separate switching of the USB 2.0 signal (see chapter 6.6.1,
page 108 or chapter 6.7.3, page 119).
Switching of USB
2.0 signals uses Extended Switching functionality (see chapter 9.1.2, page 302).
When using parallel operation within the matrix, set the
Release Time in the System Settings > Switch
menu to 10
s or more (see chapter 6.3.4, page 80). Otherwise, the connection of the USB 2.0 extender
module
will not be established due to security and stability reasons.