Ihse Draco tera enterprise 480 Series - Creating a con Device; Changing a con Device

Configuration via Management Software Draco tera enterprise
242
Field Entry/Status Description
Port Mode Activated The favorite list will be replaced by a port list where the ports from 1
to 999 can be directly selected at each matrix or Matrix Grid.
Note: The selection only works for CPU Devices and has to be
made according to the switching of favorites.
When using the Port Mode, CON and User favorites will be
deactivated.
Deactivated Function not active (default).
Redundancy Off Activated Function is not active.
Deactivated Automatically switch to the second link of a connected
redundant CON Unit when losing the primary link of a CPU Unit
(default).
Reference
Activated Activate a reference CON Device that inherits both Device and
EXT Unit settings to any CON Unit that is connected to the
matrix for the first time.
Note: It is recommended to activate the reference setting for
one single CON Device only.
Deactivated Function not active (default).
CPU Colors Selection list The CPU Device name will be highlighted according to the color
setting for text and background. You can select between 16 colors.
Fix Frame Color Selection list Show a colored frame at the CPU Device. You can select
between 7 colors. The colored frame of the CPU device is
displayed with priority to the one of the CON Device.
7.8.3.1 Creating a CON Device
To create a CON Device, proceed as follows:
1. Click Extender & Devices > CON Devices in the task area.
2. Click Activate Edit Mode in the toolbar.
3. Click New Device.
A selection dialog appears.
4. Select a real CON Device (Create a real Console) or a virtual CON Device (Create a virtual Console)
or a template of an existing CPU Device (Choose template) in the Choose template selection box.
Note: A template can only be used if there is at least on existing CON Device.
5. Click OK.
A new CON Device will be created.
6. Determine all parameters that are relevant for the CON Device.
7. Click Apply to confirm the creation.
8. Click Deactivate Edit Mode in the toolbar.
7.8.3.2 Changing a CON Device
To change settings of a CON Device, proceed as follows:
1. Click Extender & Devices > CON Devices in the task area.
2. Click Activate Edit Mode in the toolbar.
3. Select a CON Device in the CON Device list.
4. Change the desired settings.
5. Click Apply to confirm the changes.
6. Click Deactivate Edit Mode in the toolbar.