Draco tera
158 2014-04-15
8. If you have created a Master/Slave CPU Unit, select Definition >
CPU Devices in the task area of the Master Matrix and press the
New button.
A switchable CPU Device will be created.
9. Enter an appropriate extender name into the Name field.
10. Assign the previously configured Extender Unit to the just created
Device by moving the Extender Unit from the Extender available
field into the Extender assigned field and save your settings by
pressing the Apply button.
11. Connect to the Sub Matrix and repeat steps 1 to 10.
12. Select System > System Data in the task area of the Sub Matrix and
activate the Sub Matrix option.
The OSD of the Sub Matrix will immediately freeze and will be only
accessible by using the keyboard command <'Hot Key'>, <s>, <o>.
13. Restart all I/O boards on which any Master/Slave CON or CPU Units
have been configured or alternatively restart the matrix.
14. Connect the Tie Lines to the matrices. Ensure that each
Master/Slave CON on one matrix is connected to Master/Slave CPU
on the other matrix in order to achieve switchability between two
matrices.
The Matrix Cascading is now configured and can be used. Additional Tie
Lines are configured accordingly. The use of cascading is described in
Chapter
6.1.4, Page 175.
Pos: 101 /806-IHSE/Ko nfiguration/480_ Matrix/Matrix- Grid @ 10\mod_1389091114008_6. doc @ 113198 @ 2 @ 1
5.13 Matrix Grid
In this menu you can configure a Matrix Grid in order to connect two or
more matrices. This kind of configuration may become necessary if the
number of ports in the entire system has to be increased or if certain
important connections should be distributed to several matrices due to
reasons of redundancy.
The connections between two matrices have to be established by so
called Grid Lines that are connected between particular I/O ports as
connecting links. The Grid Lines can be used bidirectionally and can
respectively handle a full access connection of a CON Device to a CPU
Device.
To Next Page
Loading...