Specifications
2014-04-15 195
7 Specifications
Pos: 130 /806-IHSE/ Technische Daten/Schni ttstellen/UEB_Schni ttstellen @ 5\mod_1 278578201870_6.doc @ 42114 @ 2 @ 1
7.1 Interfaces
Pos: 131 /806-IHSE/ Technische Daten/Schni ttstellen/RJ45 ( Netzwerk) @ 7\mod_1309942 049133_6.doc @ 53692 @ 3 @ 1
7.1.1 RJ45 (Network)
The communication of the Cat X devices requires a 1000BASE-T
connection.
The cabling has to be done according to EIA/TIA-568-B (1000BASE-T)
with RJ45 connectors at both ends. All four wire pairs are used in both
directions. The cabling is suitable for a full duplex operation. For the cable
connection to a source (computer, CPU), a crossed network cable (cross
cable) has to be used.
Pos: 132 /806-IHSE/ Technische Daten/Schni ttstellen/RJ45 ( seriell) @ 8\mod_1345795 550934_6.doc @ 68062 @ 3 @ 1
7.1.2 RJ45 (Serial)
Communication takes place with a transmission speed of 115.2 KBaud,
regardless of the file format. The transmission takes place with eight data
bits and a stop bit, but without a parity bit. Limited hardware handshake
(DSR) is possible.
Pos: 133 /806-IHSE/ Technische Daten/Schni ttstellen/RJ45 ( Gerätekommunikation) @ 5\mod_1278578339308_6. doc @ 42186 @ 3 @ 1
7.1.3 RJ45 (Interconnect)
Communication of Cat X devices requires a 1000BASE-T connection.
Connector wiring must comply with EIA/TIA-568-B (1000BASE-T), with
RJ45 connectors at both ends. All four cable wire pairs are used.
Pos: 134 /806-IHSE/z z_Layout/Seitenumbr uch @ 8\mod_13485818205 16_0.doc @ 69462 @ @ 1
To Next Page
Loading...