Draco tera
48 2014-04-15
4 Installation
Pos: 40 /806-IHSE/Ins tallation/Liefer umfang prüfen/480- xxC @ 8\mod_1345735167559_ 6.doc @ 67893 @ 2 @ 1
4.1 Package Contents
Your package contains the following items:
Draco tera matrix
1x power cord per built-in power supply unit
1x serial control cable
1x RJ45/RS232 adapter
Mounting accessories
Quick Setup
1x Cat X network cable (cross-wired)
If anything is missing, contact your dealer.
Pos: 41 /806-IHSE/Ins tallation/Syste m anschließen/480- xxC @ 8\mod_1345735496377_ 6.doc @ 67913 @ 2 @ 1
4.2 System Setup
First time users are recommended to setup the system in the same room
as a test setup. This will allow you to identify and solve any cabling
problems, and experiment with your system more conveniently.
Due to the construction of the matrix chassis it is recommended to use an
additional subfloor below the matrix for the use in a 19“ rack.
Setup of the matrix
1. Connect a CON Unit to an I/O port of the matrix for its configuration.
2. Connect keyboard, mouse and monitor to the CON Unit.
3. Connect the matrix and the CON Unit to the power supply.
4. Open OSD via keyboard command <'Hot Key'>, <o> and login with
administrator rights in the main menu under configuration (see
Chapter
5.2.1, Page 58).
5. Configure initially as requested.
After the configuration of the system it is recommended to save the
configuration by selecting Configuration > Save and restart the matrix by
selecting Restart Matrix.
To Next Page
Loading...