Configuration
2014-04-15 79
Field Selection Description
activated
Starting the matrix after a restart or a
switch-on with the default configuration.
Load Default
deactivated
Starting the matrix after a restart or a
switch-on with the last saved configuration
(default).
activated
Save the current configuration of the matrix
in the flash memory periodically.
Note: During the save operation, the matrix
will not be operational. Saving takes place
every 600 seconds, as long as changes of
the configuration or switching operations
have been executed in the meantime.
Auto Save
deactivated Function not active (default)
activated
Send all switching commands performed in
the matrix as an echo via serial interface.
Note: This function should be enabled
when using a media control via serial
interface.
Enable
COM Echo
deactivated Function not active (default)
activated
Send all switching commands performed in
the matrix as an echo via LAN connection.
Note: This function should be enabled
when using a media control via LAN
connection or when using stacking with two
ore more matrices.
Enable LAN
Echo
deactivated Function not active (default)
activated
Synchronize the slave matrix to the switch
status of the master matrix.
Synchronize
deactivated Function not active (default)
activated
Synchronize the matrix according to the
echo of a second matrix.
Note: This is a bidirectional synchronization
where both matrices have to be configured
as Synchronize with the Master IP of the
respective other matrix.
Echo Only
deactivated Function not active (default)
Master IP
Address
Numerical
value
Set the network address of the master
matrix (default value: 000.000.000.000)
To Next Page
Loading...