IK Multimedia AmpliTube X-TIME - DIGITAL

AmpliTube X-TIME
Delay Models
14
DIGITAL
A crystal-clear digital delay sound, perfect for a high-fidelity wet signal. It also features a doubler mode to add
width to delay tails, a great solution to widen up any sound and fill the entire stereo field.
Parameters
• TIME: controls the time of the delay repetitions.
From 60 ms to 2000 ms or from 1/32 to 1/1T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the low-pass filter frequency. Turn it counterclockwise to filter out the high frequencies or
clockwise to get the full frequency spectrum.
From 800 Hz to 20000 Hz.
• MOD: selects the delay mode.
• NORMAL: a typical digital clean stereo in & stereo out delay.
• DOUBLER: the delay signal gets spread out the left & right channels for wide delay repeats.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• X-MODE: the X-MODE pushes the feedback to infinity.
ON or OFF.
DIGITAL Control Changes
Parameter Control Change # Values
TIME 21 0 – 127
FEEDBACK 22 0 – 127
FILTER 23 0 – 127
MOD 24 0 – 127
MIX 25 0 - 127
X-MODE 13 0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.