AmpliTube X-TIME
Delay Models
30
SLAPBACK
Bring back the ’50s with this incredible slapback delay, which also features a modulated filter to move your slap
backs in the stereo spectrum to transform this classy sound into a modern delay effect.
This Model ignores the BPM SYNC option since it is only set using milliseconds.
Parameters
• TIME: controls the time of the delay repetitions.
From 40 ms to 120 ms.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the brightness of the delay. Turn it counterclockwise to get darker tones or clockwise get
the full frequency spectrum.
From 0 to 10.
• MOD: controls the stereo LFO moving the delay left & right.
From 0 to 10.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• RATE: controls the LFO rate.
From 0.1 Hz to 5.0 Hz.
• X-MODE: the X-MODE pushes the feedback to infinity and raises the LFO resonance.
ON or OFF.
SLAPBACK Control Changes
Parameter Control Change # Values
TIME 21 0 – 127
FEEDBACK 22 0 – 127
FILTER 23 0 – 127
MOD 24 0 – 127
MIX 25 0 - 127
RATE 46 0 – 127
X-MODE 13 0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.
To Next Page
Loading...
Need help?
General
