AmpliTube X-TIME
Front Panel Overview
4
5. FEEDBACK knob
The FEEDBACK knob controls the number of repetitions occurring in the delay.
6. FILTER knob
The FILTER knob controls the frequency response of the delay.
Turn it counterclockwise to get darker delay tails or clockwise to get brighter delay tails.
7. MOD knob
The MODIFIER knob can have different purposes depending on the model such as saturation, mode
selection, modulation and more.
8. MIX knob
The MIX knob controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the
signal is fully wet. At around 85% the dry and wet signal have the same level.
9. A & B LEDs
Green if preset is active.
Amber if preset has been edited.
Blinking amber when browsing among banks.
Off if bypassed.
10. TAP LED
Blinking blue indicating the milliseconds time.
Blinking green indicating the current BPM.
Blinking amber means that the tempo is controlled by the MIDI clock.
11. A, B & TAP footswitches
Press A or B to engage or bypass preset of the current bank.
Hold A or B while preset is ON to access the X-MODE for selected model.
Hold A or B while preset is OFF to activate that preset temporary while the footswitch is held down.
Press A+B to select a lower bank.
Press B+TAP to select a higher bank.
Press TAP to tap the tempo of the delay.
To Next Page
Loading...
Need help?
General
