English
12
4.1 How to stream a processed signal
In order to stream a processed signal to your audience (e.g., an effected voice), follow these steps:
1. Set the iRig Stream Mic Pro to operate in multichannel mode as described above.
2. Open a DAW or an App, on the connected host, that supports multitrack recording.
4. Create a mono track assigning Input 3, which corresponds to the microphone front capsule. This is the track
that will be processed.
5. Insert an effect processor on this track and, if it is not on by default, activate the input monitoring. To activate
the input monitoring option on the track, please refer to the software documentation.
Usage Note: make sure that the App you’re using is set to run in Background, this allows you to use it while
you’re using other Apps (such as streaming Apps). To set the App to run in background please refer to the
software documentation.
6. Turn on the Loopback function on iRig Stream Mic Pro.
7. Now the processed signal from input 3 will come back to the inputs 1 and 2: these are the inputs usually
used by your streaming app. You can control the level of the streamed signal by using the Streaming level
control.
8. Open your preferred streaming software and start your stream. Your audience will be able to listen to the
audio that is input to channels 1 and 2.
The same steps can be followed using input 4 as the processed channel.
To Next Page
Loading...
Need help?
General
