Set the baskets at the right height
You can fold the prongs down to position pans, bowls and glasses better.
Folding down prongs
If you do not need the prongs, fold them down.
1. Push the lever forwards and fold down the prongs
2. To use the prongs again, fold them back up.
a The prongs audibly click into position
Appliance height 86.5 cm with cutlery drawe
SETTING TOP BASKET BOTTOM BASKET
1 max. ø 18 cm 34 cm
2 max. ø 20.5 cm 30.5 cm
3 max. ø 23 cm 28 cm
Before using it for the first time
Configure the settings for initial startup.
Performing the initial configuration
On initial start-up or after a reset to the factory settings, you will need to make settings.
Requirement: “The appliance has been installed and connected.” → Page 14
1. “Add special salt.” → Page 29
2. “Add rinse aid.” → Page 31
3. “Switch on the appliance.” → Page 37
4. “Setting the water softening system.” → Page 29
5. “Set the amount of rinse aid to be dispensed.” → Page 32
6. “Add detergent” → Page 33.
7. Start the Programme with the highest cleaning temperature without tableware.
We recommend you clean the appliance without tableware before using it for the first time to remove any marks from water or other residues.
Tip: You can change these settings and other “Basic settings” → Page 40 at any time.
Water softening system
Hard water leaves limescale on the tub and tableware and parts of the appliance may become blocked.
To ensure good dishwashing results, you can treat the water with special salt and the water softening system.To avoid damage to the appliance, water with a hardness above 9 °E
must be softened.
Overview of water hardness settings
You can find an overview of the water hardness values that can be selected here. You can find out how hard your water is from your local water company or by using a water
hardness tester.
To Next Page
Loading...
Need help?
General
