a. The display shows H: xx.
a. The display shows set.
3.Press or repeatedly until the display shows H:00.
4. To save the settings, press setup 3 secfor 3 seconds.
a The water softening system is switched off and the salt refill indicator is deactivated
Regeneration of the water softening system
In order to obtain the fault-free function of the water softening system, the appliance performs reheating of the water softening system at regular intervals. Regeneration of the water
softening system takes place before the end of the main rinse cycle in all programmes. It will increase the run time and consumption values, e.g. water and electricity.
Overview of consumption values with regeneration the water softening system
Here you can find an overview of the maximum additional running time and consumption values during regeneration of the water softening system. You can find the column
applicable to your model in the quick reference guide according to its water consumption in the Eco 50° programme.
WATER
CONSUMPTION
IN LITRES
(DEPENDING
ON MODEL)
REGENERATION
OF THE WATER
SOFTENING
SYSTEM AFTER
X RINSE
CYCLES
ADDITIONAL RUNNING
TIME IN MINUTES
ADDITIONAL WATER
CONSUMPTION
IN LITRES
ADDITIONAL POWER
CONSUMPTION
IN KWH
6.5 / 6.7 8 7 5 0.05
7.5 / 7.7 7 7 5 0.05
9.5 6 7 5 0.05
above 10.5 5 7 5 0.05
The consumption values specified are laboratory measurements determined in accordance with the currently applicable standard and using the Eco 50° programme and the factory
value of the water hardness is set to 16 – 20°E.
Rinse aid system
You can use the rinse aid system and rinse aid to get tableware and glasses rinsed perfectly without marks.
Rinse aid
For optimum drying results, use rinse aid. Only use rinse aid for domestic dishwashers.
Adding rinse aid
If the rinse aid refill indicator lights up, top up with rinse aid. Only use rinse aid for domestic dishwashers.
1.Press the catch on the lid of the dispenser for rinse aid 1 and lift 2.
2. Add rinse aid up to the max mark
3. If rinse aid spills out, remove it from the tub.
Spilled rinse aid can cause excessive
frothing during the wash cycle.
4. Close the lid of the dispenser for rinse aid.
a The lid clicks into position
5. To save the settings, press setup 3 sec for 3 seconds
Switching rinse aid system off
If you find the rinse aid refill indicator irritating, e.g. when using combined detergents with a rinse aid component, you can switch the rinse aid system off. Tip: The function of rinse aid
is limited with combined detergents. You will generally get better results using rinse aid.
1. Press .
2. To open the basic settings, press for 3 seconds. a The display shows H:xx. a The display shows .
3. Press repeatedly until the display shows the value set at the factory r:05.
4. Press – or + repeatedly until the display shows r:00.
5. To save the settings, press for 3 seconds. a The rinse aid system is switched off and the rinse aid refill indicator is deactivated.
Detergent
Find out which detergents are suitable for your appliance
Suitable detergents
Only use detergents that are suitable for dishwashers. Both separate and combined detergents are suitable.
For optimum washing and drying results, use separate detergent, adding
To Next Page
Loading...
Need help?
General
