a. The display shows set.
4. Press setup 3 sec repeatedly until the display shows the required setting.
5. Press or repeatedly until the display shows the right value. You can change several settings.
6. To save the settings, press setup 3 sec for 3 seconds.
7. Close the appliance door
Cleaning and servicing
To keep your appliance working efficiently for a long time, it is important to clean and maintain it carefully.
Cleaning the tub
WARNING Risk of harm to health! Using detergents containing chlorine may result in harm to health.
● Never use detergents containing chlorine.
1. Remove any coarse soiling in the interior with a damp cloth.
2. Add detergent to the detergent dispenser.
3. Select the programme with the highest temperature.
4. “Start the programme without tableware.”
→ Page 3
Self-cleaning interior
To remove deposits, the appliance selfcleans the interior at regular intervals. The programme sequence is automatically adjusted for self- cleaning, e.g. the cleaning temperature is
briefly increased. Consumption values, e.g. water and electricity, may also increase. If the interior is no longer self-cleaned adequately and deposits occur, see this information: →
“Cleaning the tub”, Page 43.
Cleaning products
Only use suitable cleaning products to clean your appliance.
→ “Safe use”, Page 1
Tips on appliance care
Follow the tips on appliance care to make sure your appliance functions properly at all times
ACTION BENEFIT
Wipe the door seals, the front of the dishwasher and the control panel regularly using a
damp cloth and washing-up liquid.
This ensures the parts of the appliance will remain
clean and hygienic.
If the appliance is not going to be used for a while, leave the door slightly ajar. This will prevent unpleasant odours.
Filter system
The filter system removes coarse soiling from the dishwashing cycle.
1 Micro filter
2 Fine filter
3 Coarse filter
Cleaning filters
Soiling in the dishwashing water may block the filters.
1. After each wash check the filters for residue.
2. Turn the coarse filter anticlockwise and remove the filter system.
● Check that no foreign objects fall into the sump
To Next Page
Loading...
Need help?
General
