IKEA finputsad User Manual

ENGLISH 13
What to do if ...
In case your dishwasher doesn’t work properly, check if the problem can be solved by going through the
following list. For other errors or issues please contact authorized After-sales Service which contact details can
be found in the warranty booklet. Spare parts will be available for a period of either up to 7 or up to 10 years,
according to the specic regulation requirements.
The spare parts can be found: https://parts-selfservice.whirlpool.com/en/landing
Problems... Possible causes... Solutions...
Salt indicator is lit
Salt reservoir is empty. (After
rell the salt indicator may
remain lit for several wash
cycles).
Rell reservoir with sal (for more information - see page 7).
Adjust water hardness - see table, page 8.
Rinse aid indicator is lit
Rinse aid dispenser is empty.
(After rell the rinse aid indicator
may remain lit for several wash
cycles).
Rell dispenser with rinse aid (for more information - see
page 8).
The dishwasher won’t start
or does not respond to
commands.
The appliance has not been
plugged in properly.
Insert the plug into the socket.
Power outage. The dishwasher starts automatically when the power returns.
The dishwasher door is not
closed
Vigorously push the door until you hear the “click”.
It does not respond to
commands. Display shows: 9 or
12 and On/O LED is blinking
rapidly.
Switch o the appliance by pressing the ON/OFF button,
switch it back on after approximately one minute and reset
the program. If problem persists, unplug the appliance for 1
minute, then plug it back in.
The dishwasher won’t drain.
Display shows: 3 and
On/O LED is blinking
rapidly
The wash cycle has not nished
yet
Wait until the wash cycle nishes
The drain hose is bent. Check that the drain hose is not bent (see INSTALLATION).
The sink drain pipe is blocked. Clean the sink drain pipe.
The lter is clogged up with food
residues.
Clean the lter (see CLEANING THE FILTER ASSEMBLY).
The dishwasher makes
excessive noise.
The dishes are rattling against
each.
Arrange the crockery correctly (see LOADING THE RACKS).
An excessive amount of foam
has been produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers (see FILLING THE DETERGENT
DISPENSER). Reset the current cycle by switching OFF the
dishwasher, then switch it on again, select a new program,
press START/Pause and close the door within 4 seconds.
Please do not add any detergent.
The dishes are not clean.
The crockery has not been
arranged properly.
Arrange the crockery correctly (see LOADING THE RACKS).
The spray arms cannot rotate
freely, being hindered by the
dishes.
Arrange the crockery correctly (see LOADING THE RACKS).
The wash cycle is too gentle and/
or detergent eciency is low.
Select an appropriate wash cycle (see PROGRAMS TABLE).
An excessive amount of foam
has been produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers (see FILLING THE DETERGENT
DISPENSER).
The cap on the rinse aid
compartment has not been shut
correctly.
Make sure the cap of the rinse aid dispenser is closed.
The lter is soiled or clogged Clean the lter assembly (see CARE AND MAINTENANCE).
There is no salt. Fill the salt reservoir (see FILLING THE SALT RESERVOIR).

IKEA finputsad Specifications

General

Brand	IKEA
Model	finputsad
Category	Dishwasher
Language	English