How to activate IKEA HYGIENISK Dishwasher?
If you cannot activate your IKEA Dishwasher, ensure that the mains plug is properly connected to the mains socket and check the fuse box for any damaged fuses.
Why are my dishes wet after using IKEA HYGIENISK?
If your dishes are wet after a cycle in your IKEA Dishwasher, consider the following: * Activate the DryPlus option and set AutoOpen for better drying. * The program may lack a drying phase or use a low-temperature drying phase. * The rinse aid dispenser might be empty. * The quality of the rinse aid could be a factor. * The quality of the multi-tablets could be the cause. Try a different brand, or activate the rinse aid dispenser and use rinse aid with multi-tablets.
What to do if I see limescale deposits in my IKEA HYGIENISK Dishwasher?
If you observe limescale deposits in your IKEA Dishwasher, check the following: * Ensure the salt level is adequate, and check the refill indicator. * Verify the salt container cap is tightly closed. * Your tap water may be hard. Refer to 'The water softener'. * Even with multi-functional tabs, use salt and set regeneration of the water softener. Refer to 'The water softener'. * If deposits persist, use appliance cleaners specifically for limescale. * Try a different detergent. * Contact the detergent manufacturer for further advice.
Why are there water spots on dishes from IKEA HYGIENISK Dishwasher?
If you see stains and dry water drops on your glasses and dishes after using your IKEA dishwasher: * Increase the rinse aid level if it's too low. * Consider that the quality of the rinse aid might be the issue.
How to activate my IKEA HYGIENISK Dishwasher?
If you cannot activate your IKEA Dishwasher, ensure that the mains plug is properly connected to the mains socket and check that there is no damaged fuse in the fuse box.
What causes unusual foam during washing in IKEA HYGIENISK?
If you notice unusual foam during washing in your IKEA Dishwasher: * Make sure you are only using detergent specifically designed for dishwashers. * There may be a leak in the rinse aid dispenser. If so, contact an Authorised Service Centre.
Why is there rust on my IKEA HYGIENISK Dishwasher cutlery?
If you notice traces of rust on cutlery after using your IKEA dishwasher: * There may be too much salt in the water; refer to "The water softener" section. * Avoid placing silver and stainless steel cutlery together.
What to do if there are residues of detergent in the IKEA Dishwasher dispenser at the end of the programme?
If there are residues of detergent in the dispenser of your IKEA Dishwasher at the end of the program, the detergent tablet might have been stuck in the dispenser and not completely washed away by water. Also, water might not be able to wash away the detergent because the spray arms are blocked or clogged. Finally, ensure that items in the baskets do not prevent the detergent dispenser lid from opening.
What to do if my IKEA Dishwasher does not drain the water?
If your IKEA Dishwasher doesn't drain water and the display shows an error, check these items: Ensure the sink spigot, the filter in the outlet hose, and the interior filter system are not clogged. Also, make sure the drain hose has no kinks or bends.
What to do if my IKEA HYGIENISK Dishwasher is not draining?
If your IKEA Dishwasher isn't draining water and the display shows an error, check the following: * Ensure the sink spigot is not clogged. * Make sure the filter in the outlet hose is not clogged. * Verify the interior filter system is not clogged. * Confirm that the drain hose has no kinks or bends.
General| Type | Built-in |
|---|---|
| Water Consumption per Cycle | 9.5 liters |
| Child Lock | Yes |
| Features | Rinse aid indicator, Salt indicator |
| Delay Start | 1-24 hours |
Appliance can be used by children aged 8+ and persons with reduced capabilities if supervised. Keep young children away unless supervised.
Intended for household and similar applications. Do not change specifications. Follow water pressure, place settings, and cord safety rules.
Warning! Only a qualified person must install this appliance. Follow instructions and ensure safe placement.
Warning! Risk of fire and electric shock. Ensure correct grounding, socket, and cable connections.
Do not damage water hoses. Ensure no leaks. Water inlet hose has a safety valve.
Covers opening tap, activating appliance, filling containers, loading baskets, adding detergent, and starting.
Instructions on placing detergent or multi-tablets in the compartment and usage advice.
Guide on pressing programme buttons, activating options, and closing the door.
How to use AUTO programme and set a delayed start time.
Introduces a table of common issues and their possible causes and solutions.
Solutions for issues like not starting, filling, draining, flood device, and technical malfunctions.
Solutions for door problems, rattling sounds, and poor washing/drying results.
To Next Page
