14
Installation and connection
Installation and connection
To ensure proper operation, connect
the appliance to the power and water
supply correctly. Observe the specified
criteria and the installation instructions.
Scope of supply
After unpacking all parts, check for any
damage in transit and completeness of
the delivery.
If you have any complaints, contact IKEA
or our Customer Service.
Note:The appliance was tested at the
factory to check it is in working order. It
is possible that water has left marks on
the appliance. These marks will disap-
pear after the first wash cycle.
The delivery consists of the following:
● Dishwasher
● Operating instructions
● Installation Instructions
● Installation material
● Steam guard plate
● Mains cable
● Quick reference guide
Installing and connecting the
appliance
You can position your built-under or in-
tegrable appliance in a fitted kitchen
between wooden and plastic walls. If
you subsequently install your dish-
washer as a free-standing appliance,
you must stop it from tipping over, e.g.
by screwing it to the wall or installing it
under a continuous worktop that is se-
curely connected to adjacent cabinets.
1. Follow the safety instructions.
→Page5
2. Follow the instructions for electrical
connection. →Page15
3. Check the Scope of supply and the
condition of the appliance.
4. Consult the installation instructions
for the installation dimensions re-
quired.
5. Make the appliance level using the
height-adjustable feet.
Make sure that the appliance is
standing on the floor securely.
6. Install the drainage connection.
→Page14
7. Install the drinking water connection.
→Page15
8. Connect the appliance to the power
supply.
Drainage connection
Connect your appliance to drainage
connection so dirty water is discharged
via the wash cycle.
Installing the drainage
connection
1. Consult the installation instructions
supplied for the steps required here.
2. Connect the wastewater hose to the
outlet connection of the siphon using
the enclosed parts.
3. When doing so, check that the
wastewater hose is not kinked,
crushed or twisted.
4. Also check that there is no cover in
the drainage system preventing the
wastewater from being discharged.